What a weekly pool cleaning visit includes
A weekly service visit is not a quick skim and a wave from the truck. Our technician works through the same checklist at every pool, every week, because consistency is what keeps water clear. We skim the surface for leaves, pollen and insects, brush the walls, steps and tile line, empty the skimmer baskets and the pump basket, vacuum the floor, test the water and add the chemicals it needs. Before we leave we blow off the deck and surrounding area so debris does not end up right back in the pool.
Water testing is the part most homeowners skip when they try to do this themselves. We test free chlorine, pH, total alkalinity, calcium hardness and cyanuric acid, and we test for phosphates when a pool starts fighting us. Chemicals are added based on the reading, not on a guess, and every dose is logged so we can see trends over the season.
Filter pressure is checked on each visit. When the gauge climbs 8 to 10 psi above the clean starting pressure, a sand or DE filter gets backwashed and a cartridge filter gets pulled and hosed down. Ignoring filter pressure is the most common reason a pool that gets chemicals still turns cloudy.
- ■Skim the surface and brush walls, steps and tile line
- ■Empty skimmer baskets, pump basket and any cleaner bag
- ■Vacuum the floor as needed
- ■Test free chlorine, pH, alkalinity, calcium hardness and CYA
- ■Add and log chemicals (billed at cost)
- ■Check filter pressure, pump operation and water level
- ■Blow off the deck and surrounding area
Why weekly service matters in central Mississippi
Pools in Madison, Ridgeland and Gluckstadt live in a harder climate than most of the country. Our swim season runs from March into October, and for a good part of that stretch water temperatures sit in the mid 80s or higher. Warm water burns through chlorine faster and gives algae a head start. Add the humidity, afternoon thunderstorms that dump dirt and organic debris into the pool, and a pollen season that coats the surface in yellow film every spring, and a pool that goes two weeks without attention can go from clear to green.
Weekly pool cleaning in Madison, MS is about staying ahead of that curve. Chlorine demand is checked and corrected before it bottoms out. Debris comes out before it sinks, decays and feeds algae. Brushing breaks up the biofilm that algae grows from before it becomes a visible patch. The pool never gets far enough behind to need a rescue.
Bi-weekly plans work for some pools, usually screened enclosures, well-shaded lots or pools with a very reliable automatic cleaner and a saltwater system. For an open pool near trees in Madison County, weekly is the plan we recommend and the one that produces the fewest surprises.
Water chemistry targets we hold your pool to
Balanced water protects swimmers and the pool itself. We aim for free chlorine between 1 and 3 ppm in a traditionally chlorinated pool, and we hold it toward the higher end of that range in July and August. pH stays between 7.4 and 7.6, which is the window where chlorine works efficiently and water is comfortable on eyes and skin. Total alkalinity between 80 and 120 ppm keeps pH from swinging after a rain or a chemical addition.
Calcium hardness should sit between 200 and 400 ppm for plaster and pebble pools. Water that is too soft will pull calcium out of the plaster; water that is too hard will leave scale on tile and inside the salt cell or heater. Cyanuric acid, the stabilizer that shields chlorine from sunlight, is kept in the 30 to 50 ppm range. Above that, chlorine becomes sluggish and you need more of it to do the same job, which is why we do not rely on stabilized tablets alone all season.
Phosphates feed algae. A pool that is holding chlorine but still growing algae along the steps usually has a phosphate problem from lawn fertilizer runoff, decaying leaves or fill water. We test for it when a pool acts that way and treat it with a phosphate remover rather than just throwing more chlorine at the symptom.
Brushing, vacuuming and filter care
Brushing is the step that separates real pool service from a skim-and-go route. Algae starts as a slick film on plaster, in corners, on steps and behind ladders long before it turns the water green. A stiff brush on plaster, or a nylon brush on vinyl and fiberglass, breaks that film loose every week so chlorine can kill it in open water. We brush the tile line as well to keep calcium and body-oil scum from building up.
Vacuuming removes what the skimmer cannot: fine dirt, sand, pollen that has sunk and the dead algae left after any treatment. Pools with a functioning robotic or suction cleaner need less manual vacuuming, but we still spot vacuum every visit and do a full floor vacuum whenever the pool needs it.
Filter type changes how we maintain the pool. Cartridge filters are common on newer builds in Gluckstadt and Flowood and need to be hosed down every few weeks in peak season and deep cleaned once or twice a year. Sand filters get backwashed on pressure rise and the sand replaced every 5 to 7 years. DE filters filter the finest and need a backwash plus a fresh DE charge, with a full grid teardown at least once a year. We track all of it as part of your weekly plan.
Equipment checks on every visit
Most expensive pool repairs start as something small that nobody noticed. On every weekly visit we look at the pump for air in the strainer lid, listen for a bearing starting to whine, check for drips at the unions and look at the filter gauge. On saltwater pools we check the cell output reading and look for scale on the plates. Low water level, a stuck weir door on the skimmer or a clogged pump basket will all cut circulation, and poor circulation is the second most common reason for algae after low chlorine.
We will not do unauthorized repairs. If we spot something that needs attention, you get a text with a photo and a plain explanation of what it is, what it will cost and whether it can wait. Most homeowners in Madison and Ridgeland tell us that early warning alone pays for the service.
How our monthly plans work
Weekly service is four visits per month; bi-weekly is two. Both run on a 6-month minimum, which covers one full swim season and gets you through the pollen and storm months when a pool needs it most. Chemicals are billed at cost with no markup, so you pay for what your pool actually used, not a flat chemical fee that guesses high.
You get the same technician on the same day each week whenever possible. After each visit you receive a short report with the test readings, what was added and any notes about equipment. If you are out of town, the pool still gets serviced and you still get the report.
Plans are available across our service area: Madison, Ridgeland, Gluckstadt, Canton, Flora, Flowood, Brandon, Jackson, Clinton and Pearl. If your neighborhood is not on that list, call and ask. We add routes where it makes sense.
Weekly pool cleaning for homeowners, rentals and HOAs
Most of our weekly pool cleaning clients in Madison, MS are homeowners who want to use the pool on the weekend without spending Saturday morning on it. We also maintain short-term rental pools, where a green pool means a refund and a bad review, and neighborhood pools for HOAs in Madison County and Rankin County that need documented chemical logs. Commercial and HOA pools are priced per property based on size, bather load and how often they need to be checked.
If your pool is already clear, we can start weekly service right away. If it is cloudy or green, we will quote a one-time vacuum visit or a green-to-clean recovery first, then move you onto the weekly plan once the water is where it needs to be.
Where we work
Weekly Pool Cleaning & Maintenance is available across Madison County and the Jackson metro — Madison, Ridgeland, Gluckstadt, Canton, Flora, Flowood, Brandon, Jackson, Clinton, and Pearl.
Questions we get
How much does weekly pool cleaning cost in Madison, MS?+
Most pools run about $225 a month for weekly service (four visits a month) and about $150 a month for bi-weekly (two visits). Chemicals are billed at our cost on top of the plan, and every dose is logged on your visit report. Pool size, tree cover, and equipment can move the price a little either way, so text a photo to 601-967-1717 and we will send a firm number, usually the same day. Monthly plans carry a six-month minimum.
Are chemicals included in the monthly price?+
Chemicals are billed at cost, separately from the service plan. You pay for exactly what your pool used each month, and every dose is logged on your visit report.
Do I need to be home for the visit?+
No. Most clients are at work when we come. We need access to the backyard and the equipment pad. You receive a report after every visit with readings and notes.
Is bi-weekly service enough for my pool?+
It can be for a screened, shaded pool with a good automatic cleaner or a saltwater system. For an open pool near trees in Madison County during the March to October season, weekly is what we recommend.
What happens if my pool turns green between visits?+
On a weekly plan that is rare because we catch chlorine demand early. If a storm or equipment failure causes it, we quote a green-to-clean recovery visit and get it back on schedule.
Which areas do you serve for weekly service?+
Madison, Ridgeland, Gluckstadt, Canton, Flora, Flowood, Brandon, Jackson, Clinton and Pearl. Call if you are nearby and not on the list.
What actually happens during a weekly visit?+
Walk up, read the water with a drop kit, look at the equipment. Pull both baskets, skim, brush, vacuum. Dose chlorine and acid to the test, backwash if the gauge is up, log the readings and leave. Thirty to forty-five minutes on a normal pool, same day every week.
What happens if I skip service for a month in the summer?+
Skip 30 days in July and by day 5 the chlorine is gone, day 8 it is cloudy, day 12 it is green, day 20 the skimmer clogs and the pump runs dry. That is about a $500 fix; a month of weekly service is about $225.
Why is there always dirt on the bottom even though the pool gets cleaned?+
Fine dirt gets past the filter, or the pump does not run long enough to pull it in. Brush it: if it clouds up, it is algae, not dirt. Check filter pressure and add pump hours.
My pump will not turn on. What do I check first?+
Check the breaker and the timer first. A hum with no spin is usually a capacitor or a jammed impeller; silence is power or a dead motor. Do not keep trying to start it, and add liquid chlorine by hand until it is fixed so the pool does not go green.